Bottom fishing with the use of rubber shock absorber is called rubber band. This gear is very efficient and interesting. Catch it both peaceful and predatory fish. In addition, it is able to sh in all depths. How to catch a fish on a rubber band?
Advantages and disadvantages
As with all gear it has its advantages and disadvantages.
Advantages:
Able to catch at all depths without changing the position of tackle.
Uses a variety of baits. Allowed the combination of living and non-living baits.
No need to throw a sinker after luring fish and during the change of the nozzle.
Quick change collars
Fishing both from a boat and from shore
Compactness.
Disadvantages
The complexity of the design, a lot of hooks, leashes, which are constantly mixed up between each other.
For casting a long distance, you need to make a little effort or a boat.
A strong current will sail gear, which will degrade the sensitivity of the tackle.
On the course of the hooks can collect the floating debris.
Someone to catch elastic
Use this tackle in standing water or slow current. Catch both peaceful and predatory fish. Often catch carp, bream, roach, pike, perch and Rudd.
Items gum
Fishing line. For basic use durable and wear-resistant thread with a diameter of 0.40 mm. For leash use fishing line of a smaller diameter. For carp, take a diameter of 0.16 – 0.20 mm. For predatory fish take the leash of 0.30 – 0.40 mm.
Hooks. Pick up of fishing circumstances. For predator take hooks double and triple offset. For peaceful fish take hooks No. 8 – 12.
Cargo. Importantly, he held the line on the fishing spot. It is important that its location has not changed. For very large sinkers you will need a boat, so how far you throw.
Rubber. Best suited with a circular cross section, and is able to stretch several times.
Swivels and tees. They cut the tabs and twisting gear, as well will increase the efficiency and facilitate the replacement leads.
Fishing technique
Need to find a place with no current or with as little as possible. On the shore you need to have a smooth area. It is necessary for safety when casting. Water should not be twigs, algae or reeds.
Prepare the right bait. For a predator needs to catch fry, but for peaceful fish to prepare the bait.
Lay on the Bank tackle. Unwind it in the form of a snake from left to right. Hooks spread out as far as possible from each other.
To a stick or short rod, tie the free end of the line. A stick set in the Bank.
Prepare a rod which you’ll be casting.
Insert the rod into the eyelet sinkers.
Stand so the tackle was from the side from you.
No swing dramatically complete the cast. After casting upregulate quickly to the side.
After casting, pull the main line to each of the leash and attach the bait on the hooks. Drop the line back in the water.
On the main fishing line attach the indicator poklevki.
For fishing carnivorous fish need to feed her. Lure throw the entire length of the main line. When it comes to the fish throw the bait closer to the gear, to the lure lay on the bottom near the hooks.
You can catch actively and stationary. With the active form of fishing you need to constantly SIP on for the main line and cause the leashes to walk around. For stationary fishing manipulations do not hold. They are caught in a small current, in this case, the leads themselves will play.
Cutting produces sharp movement itself. Pull too hard is not necessary, as the fish can go and confuse the tackle.
The bait correct or replace and throw her again.
If was torn off the hook or leash again to pull the bait to the shore and replace them with new ones.
For fishing with gum only need to use a fresh rubber band with a circular cross section.
Bait it is desirable to combine.
Always keep a few hooks and collars, to be quickly replaced. It is desirable to have sets of both the predator and peaceful fish.
How to catch a fish on a rubber band video
How to assemble the rubber band
To try to catch a fish on a rubber band, you can Zavidovo fishing.