Промер глубины маховой удочкой, фидером

Work marker is divided into soundings and determining the status of the bottom cover and its topography. To understand what the depth and bottom in the desired fishing location is made card measurements. For this you need a notebook in the box and a pencil. The mark point with which the angler, and the landmarks on the opposite shore, within which are the measurements.

For greater accuracy, these targets should be few, with approximately equal distances between them. In the direction of these guidelines and made casts. In your notebook draw a picture with these directions from a point, which makes the casting angler. You should start with measuring the depth at casting on the first and each subsequent directions.
Measuring depth is

Made a few casts to the chosen fishing spot. The cargo is allowed to reach the bottom. Gently exhausting the slack of the line until the mechanical thrust of the float to a sinker at the bottom. The rod tip should look on line. Baitrunner disables the main clutch coil. The clutch of baitrunner should be in good shape so to prevent the overrun of the line and not to interfere with the fisherman when the fishing line otmuchivanie hand during the measurements.
The fishing line is captured by a hand roller line bale and smoothly drops to the level of half a meter, while the float does not seem out of the water. The number of half slopes of the line are summed and divided by 2 – it turns out the depth in meters. The result is added cut incomplete polumetrovye – if this happens, the angler will know the depth below the float.
The float is pulled back to the sinker to push. The fishing line is clamped in the clip on the spool and starts the determination of the distance of the throw by winding the fishing line. Pre-determined by how much fishing line is wound on a spool for one turn of the handle coil. Then the fishing line unwound, and is considered the momentum arm of the coil, while the snap does not reach the water’s edge. Multiplying the number of turns of the knob for a length of fishing line, cut in one revolution, the angler gets the casting distance.
About the cells, is set at the scale point of the first casting and specify the distance and depth. After that, the cast to this point is repeated – the line from the spool will come down to clips. Important the accuracy of the throw, the fishing line to the rod, spruing not pulled the snap back on themselves. Then measuring the depth is repeated. The result should roughly coincide with the first measurements. The float is lifted to the load and rigging stretches the rod along the bottom to shore. When the rod takes the position of a right angle with the direction of the cast, or the angler will feel a change in how moves along the bottom of the snap, the rod tip goes to the point of casting, the reel is selected as the slack of the fishing line to push the float on the cargo, and the number of turns of the knob is determined by the distance that close to the shore shifted the snap.
Again measured depth and is indicated in the figure. Then the whole process is repeated the desired number of times angler.

Centrifugal float rod, the measurement depth seminar
Soundings of the depth of the feeder